Elektron Monomachine Manual do Utilizador descarregar pdf (Página 58)

THE PATTERN SEQUENCER

STEP RECORDING

The third method of recording notes differs a bit from the other two methods as data is input

on a step by step basis. You can input notes from the keyboard and the [TRIG] keys

1. Begin with following the instruction in section “REC

ORDING PREPARATIONS”, on

page 47.

2. To enter STEP RECORDING mode, press [REC] and [STOP] at the same time.

3. The pattern will start on the first step of the sequencer. From here the active position will

automatically advance one step forward when a note or chord is programmed.

4. You can use the [LEFT] and [RIGHT] keys to move the

editing focus of the pattern.

Press the [EXIT/NO] key to program a NOTE OFF, press [ENTER/YES] to clear a note.

• Use the step recording method as an experimental way of creating patterns. Inter-

esting results can be had!

NOTE COPY

It is possible to copy a note trig, complete with all parameter lock settings, and paste it to a

new location in the track.

1. Make sure you are in GRID RECORDING mode, indicated by the <RECORD> LED giv-

ing off a steady light.

2. Press and hold the note trig you want to copy and press the [RECORD] key. A message

“COPY NOTE” will appear.

3. Hold the [

TRIG] key correspondning to the location you want to paste the note to and

press the [STOP] key to complete the paste operation. A message “PASTE NOTE” will

be shown.

CLEAR NOTE PARAMETER LOCKS

Instead of removing the parameter locks from a note you can also use the clear note locks

command.

1. Make sure you are in GRID RECORDING mode. The <RECORD> LED should be lit.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 157 158

Sem comentários

Elektron Monomachine Manual do Utilizador Página 58